1. Login to the console of the appliance
You will need to open a console session to the appliance for your hyper-visor of choice. Log in with the local admin credentials you were provided in the Kickoff. Contact Support if you or your site admin doesn't have them.
1. Setup networking
You can use either a DHCP assigned address or a static IP ( recommended ). If you are uncomfortable setting up networking in Ubuntu 16.04 follow the below steps. From the console enter the following based on your needs
- To check current settings type:
- To set the system to use DHCP type:
- To set a stacic ip type:
network static <address> <subnet> <gateway> <dns>
- To see a list of all options type:
- exit smash with
2. Mount Data Drive
After adding your secondary drive in the appliance setup you will need to mount it. From the console enter the following.
- To mount a drive:
sudo verimount --operation mount --destination /data --source /dev/sdb --type xfsif your drive resides at a different location that /dev/sdb you should substitute that here.
- More verimount documentation is found by running
sudo verimount --help
After completing all the steps on the page, reboot the host; then log back in and:
sudo veridocker -o start
This will download and start the FileHub application.